Do you know how to solve the problem when the electronic belt weigher spreads materials? The corresponding solution should be found according to the unnecessary reason. Through scientific research, the following proposals are made:
1： Scattering at the reference point: raw materials at the reference point are easy to be scattered to the electronic belt weigher silo, guide chute and other places, which is very dangerous, so be careful in actual operation. For example, the plastic side skirt of the guide chute of the belt conveyor is damaged due to the important load of the belt belt conveyor, and the thick steel plate at the guide chute is far away from the belt in the design scheme, so that the raw materials break through the guide chute. The above problems can be solved by controlling transportation and improving maintenance.
2： When the concave belt is suspended in the air, the problem of scattering materials will occur: for the concave belt section, when the angle of the concave section is relatively small, the belt will be suspended in the air. At this time, the situation of the belt groove will change, because the belt has already arrived at the groove idler group, and some groove angles will shrink, causing some raw materials to be scattered in.
Therefore, in the planning of the electronic belt weigher link, a relatively large concave angle should be used to avoid this kind of situation.
3： When the direction of the electronic belt weigher deviates, the problem of scattering materials will occur: this is a common problem. The scattering materials after the belt direction deviates mainly because the relative height of the two edges of the belt changes during operation, one side is high, the other side is low, and raw materials are spilled from the low side. The solution is to correct the direction deviation of the electronic belt weigher belt in time.
The above is the brief information of the belt weigher manufacturer. I hope it can help you.
